Why does my programmer display "The LPT Driver can't be opened"? (LabTool-48XP/48UXP/848XP) |
| Dear Sir, |
| The problem is caused because the user has not un-install the previous program, forget to restart computer, open the program more than two times, or login non-administrator (on NT or Win2000). |
| |
| The main operation during the installation procedure is updating newly Win drivers, which drivers are modified. If the Win drivers have not been copied to the correct directories, or have not been started, then the software will not work correctly. |
| |
| However, the failure of opening drivers is due to some other procedures. |
| |
We have made a patched file consists of the Win drivers and auto registry procedures. The patched file is named 'AecDrXP5.exe', which is attached in this e-mail. |
| |
Please follow the steps, |
- Execute the 'Add or Remove' program from the control panel.
- Select the previous program, which is installed before.
- Restart your computer.
- Execute the 'wadvx530.exe' (or wadvx???.exe)
- Execute 'Setup.exe' from the DISK1
- Re-start your computer when the installation was done.
- Save 'AecDrXP5.exe' into 'C:\' (or any directory).
- Execute the 'AecDrXP5.exe' (the files are extracted into the 'C:\AecDrXP5' directory).
- Open the directory 'C:\AecDrXP5'.
- a. If your PC is Windows95, then execute the file 'Setup95.bat'
b. If your PC is Windows98, then execute the file 'Setup98.bat'
c. If your PC is WindowsMe, then execute the file 'SetupME.bat'
d. If your PC is Windows2000, then execute the file 'Setup2k.bat'
e. If your PC is WindowsNT, then execute the file 'SetupNT.bat'
f. If your PC is WindowsXP, then execute the file 'SetupXP.bat'
- Restart your computer again.
- Execute the software 'LabTool-48XP' ICON.
- If the failure of opening drivers was found, then close the program of LabTool-48XP and go to step 10.
|
| |
Sincerely yours,
ADVANTECH EQUIPMENT CORP. |
